Documentation
Your first vault
About fifteen minutes, start to finish. Every step is signed by your own wallet AutonomyHQ never holds a key that can move your funds.
- Install the Casper Wallet extension and switch it to testnet.
- Fund your account at the testnet faucet
- Open the app, go to My Vault, and connect your account.
- Set your spending cap, max per trade and approved destinations. Destinations are Casper addresses (64 characters) leave it blank and only your own account is approved, which is the safest setting.
- Press Deploy my vault. Your wallet signs; you become the owner. The app waits for the network to confirm before saving anything.
- When it confirms, the Add funds dialog opens automatically. Deploying a vault does not move any CSPR into it a contract cannot take your funds, you have to send them. This signs with your wallet too.
- Press Sign policy register. This writes your limits to the contract (set_policy) and authorises the agents (register_operator), so expect two wallet prompts.
- Press Start agents. It stays greyed until a wallet is connected and a vault exists.
If a trade is rejected, the error code says why.
2 the agents are not authorised press Grant agent access.
4 the destination is not on your approved list.
5 over your max per trade.
6 over your 24-hour cap.
7 the vault is empty press Add funds.
8 no policy on the contract yet press Sign policy register.
Prefer the command line?
Every step above has a CLI equivalent — see CLI commands.